JYW 400/AP Warping Machines

Diameter of the application beam is below value="400" tcsc="0" unitname="mm" w:st="on">400mm, diameter of inside hole is value="17" tcsc="0" unitname="mm" w:st="on">17mm or value="20" tcsc="0" unitname="mm" w:st="on">20mm, inside length is value="300" tcsc="0" unitname="mm" w:st="on">300mm.

Speed Adjustment

Frequency control: 0 ~350r/min.(Line Speed0~value="390" tcsc="0" unitname="m" w:st="on">390m/min)

Set Length

Use the counter to set any warp length according to the requirement, this measure can reduce the loss of warp.

Width and Density adjustment  

Adopt 4 pieces of W-reed; adjust width and the left and right device randomly.

Motor   2HP/4P/380V3Phase